Uncategorized

Learn how to Make a Wood Reducing Board in 6 Steps

admin

This undertaking is an efficient one for cooks who desire a long-lasting butcher block reducing board that will not warp over time or transfer as they use it. An added bonus is the curved notch at one finish that means that you can scrape meals from the reducing board straight into your bowl cheese board set B086WX8JBZ.

Step 1: Determine on the design, dimensions and supplies you can be utilizing in your reducing board. Assemble the required instruments and supplies. Since you can be utilizing a number of energy instruments, make sure to put on safety glasses. Additionally, have a face mask for whenever you sand the reducing board.

Step 2: Assemble the butcher block. Reduce three 17-inch lengths of 2-inch thick clear maple on the miter saws. NOTE: These are straight cuts, not miter cuts.

Alternate the wooden grain by flipping the center board over in order that its grain runs counter to the outer two boards. Apply wooden glue to the sides of the board the place they may be part of. Clamp them collectively whereas the glue dries.

Step 3: Easy the butcher block. Use a belt sander to flatten the reducing board floor so there isn’t a noticeable ridge/transition from board to board. To do that, first transfer the sander throughout the boards in a diagonal movement. As soon as the transition is clean, sand with the grain alongside the size of the boards.

Change to a random orbit sand and to progressively finer grades of sand paper till the floor of the reducing board has no discernible texture.

Trim one finish of the board on a desk noticed. Place the board in a wood cradle that holds the wooden regular as you slide it into the blade. Reduce solely a skinny strip off the top, to clean the sides of the three boards you glued collectively. Set up which facet of the board would be the high – usually the floor with the extra enticing wooden grain.

Step 4: Notch the reducing board. Flip the board so the underside facet faces upward and draw a semicircle on the unfinished finish with a compass and pencil.